How the quiz works
Choose the levels and the way you want to be tested, then press Start quiz. Each question builds a new signal: you hear it once while its waterfall fills in from the top, and four names wait below. Pick one. The waterfall then shows the numbers that identify the mode, such as the gap between two tones or the length of a transmission, and a note says what to listen and look for. Space plays the signal again as often as you like.
Every mode has a mastery level from 0 to 5: a right answer adds one and a miss takes two away. A mode counts as learned at level 3. Modes you miss come back two to four questions later, and modes you know well come up less often. The wrong answers are chosen from modes that are easy to mistake for the right one, so FT8 meets FT4 and WSPR, and SSTV meets weather fax.
Sound only hides the waterfall until you answer. Waterfall only shows the whole waterfall at once and stays silent until you answer, which is closer to scanning a band with the sound turned down. Learn the signals opens a library where you can play every mode, see its measurements and read how it sounds.
Levels and conditions
Level 1 has eight modes that look and sound clearly different. Level 2 adds eight that are easily confused with them or with each other, such as NAVTEX and RTTY, or the three multi-tone modes. Level 3 is for practised ears: two faster or wider versions of modes you already know, two radars and the case where there is no data at all.
Level 1 signals are strong and steady. From level 2 on the signal fades in and out, the noise is stronger and a weaker station often sits beside it, so the question asks for the strongest signal. With Sometimes on the wrong sideband about one signal in three arrives as a receiver set to LSB instead of USB would play it: mirrored in frequency, so a tone that should rise falls.
The signals
| Mode | Level | What gives it away | Where to hear it live |
|---|---|---|---|
| Morse code (CW) | 1 | One tone keyed in dots and dashes; a dash is three dots long | 7.000–7.040 and 14.000–14.070 MHz |
| RTTY, 45 baud | 1 | Two lines 170 Hz apart lighting up in turn, 22 ms a bit | 14.070–14.099 MHz, contests |
| PSK31 | 1 | One thin steady trace, a whistle with a gentle flutter | 14.070, 7.040, 3.580 MHz |
| SSTV | 1 | 1500–2300 Hz picture tones with a 1200 Hz sync pulse each line | 14.230, 21.340, 28.680 MHz |
| Weather fax | 1 | 1500–2300 Hz, mostly white, repeating every 0.5 s, no sync pulses | 7880 and 13882.5 kHz (German weather service) |
| FT8 | 1 | 50 Hz blocks that start together and last 12.6 s of every 15 s | 14.074, 7.074, 3.573 MHz |
| APRS packet | 1 | Short bursts on 1200 and 2200 Hz with FM hiss between them | 144.800 MHz (Europe), 144.390 MHz (North America) |
| Time signal | 1 | A steady tone that dips or stops exactly once a second | 77.5 kHz (DCF77), 60 kHz (MSF) |
| NAVTEX | 2 | Two lines 170 Hz apart, busy all the time, 10 ms a bit | 518 and 490 kHz |
| RTTY, 50 baud | 2 | Two lines 450 Hz apart lighting up in turn, 20 ms a bit | 7646 and 10100.8 kHz (German weather service) |
| FT4 | 2 | 83 Hz blocks lasting 5 s, in 7.5 s slots | 14.080 and 3.575 MHz |
| WSPR | 2 | Traces about 6 Hz wide that last almost two minutes | Dial 14.0956, 10.1387, 7.0386 MHz |
| Olivia 8/500 | 2 | A 500 Hz block of short dashes on eight tones, a new one every 16 ms | Data segments, e.g. 14.0715 MHz |
| MFSK16 | 2 | 64 ms steps on 16 tones 15.6 Hz apart | Data segments, e.g. 14.0725 MHz (rare) |
| Feld Hell | 2 | One frayed line about 300 Hz wide; a Hell receiver prints letters | Data segments (rare) |
| PSK63 | 2 | A steady trace twice as wide as PSK31, buzzier | Near 14.070 MHz |
| PSK125 | 3 | A steady trace four times as wide as PSK31 | Near 14.070 MHz |
| Olivia 32/1000 | 3 | A 1000 Hz block of dashes on 32 tones, a new one every 32 ms | Data segments (rare) |
| Ionosonde | 3 | A zip across the whole passband in about 30 ms | Anywhere from 2 to 30 MHz |
| Over-the-horizon radar | 3 | A buzz filling the passband with lines 40–67 Hz apart | About 6–30 MHz, often in amateur bands |
| No data | 3 | A line that never breaks; interference may drift and buzz | Everywhere |
How the signals are made
Nothing here is a recording. Each signal is generated from the published parameters of its mode: the tone frequencies, the symbol rate, the shift between tones, the sync patterns and the timing of a transmission. The texts are invented and the stations use the placeholder call sign N0CALL. The data tones of FT8, FT4, WSPR, Olivia and MFSK16 are random and carry no message; the sync patterns of FT8, FT4 and WSPR follow their specifications. The Morse, RTTY, PSK, SSTV, weather fax, NAVTEX, APRS and time-signal generators are adapted from the demo signals of the site’s decoders.
The page then places the signal at a random audio frequency between 300 and 2700 Hz, as tuning a receiver would. Picture modes keep their standard tones with a small tuning error, and APRS keeps its 1200 and 2200 Hz tones, because an FM receiver does not shift them. Noise shaped like the filter of a receiver in USB mode (about 250 to 2800 Hz) is added at a random strength. APRS gets the hiss of an FM receiver with an open squelch instead, which drops while a packet is on the air.
A real band is messier. Signals drift, echo and splatter, interference comes and goes, and a busy FT8 segment holds dozens of stations rather than a handful. Use the quiz to learn the shapes and rhythms, then listen on a receiver; the table above says where.
Every answer screen and the library have Save as WAV, so a signal can serve as a test file for other programs or for the matching decoder of this site, which reads Morse, RTTY, PSK31 and PSK63, SSTV, weather fax, NAVTEX, APRS and the DCF77 and MSF time signals. For Morse, RTTY, PSK and APRS the file is the clip you heard. NAVTEX, SSTV, weather fax and time-signal decoders lock on to the start of a transmission, which a short clip seldom has, so for those modes the file is a longer example of the same mode that begins there: 40 seconds of NAVTEX, a minute of SSTV from its header, 45 seconds of fax from its start tone, and 80 seconds of a time signal, enough for one full minute of time code. On 14 November 2026 a script in the site’s repository saved files this way for every decodable mode, several examples each, and the matching decoder here read back the text, packets, picture or time from every one.
Controls
- Mouse or touch: click or tap an answer, then Next. Play again repeats the signal and stops it while it plays; Zoom switches the waterfall from 3 kHz to 750 Hz and 150 Hz around the signal. The buttons under the screen end the session, open your progress, set the volume and switch to full screen.
- Keyboard: on the start screen Space switches an option and Enter starts the quiz. In the quiz 1–4 pick an answer, the arrow keys move between answers and Enter picks one, Space plays the signal again or stops it, Enter goes to the next question, Z changes the zoom, Esc ends the session and F toggles full screen.
- Library: the arrow buttons or the list pick a mode, ← and → step through the modes, Space plays the example, N makes a new example, Z zooms and Esc goes back.
Frequently asked questions
Why does FT8 look like a solid block?
At the 3 kHz zoom one column of the waterfall is about 12 Hz wide, wider than the 6.25 Hz between FT8 tones. Press Zoom once: at 750 Hz a column is about 3 Hz wide and the eight tones separate. WSPR needs the 150 Hz zoom, where its four tones 1.46 Hz apart show as a narrow wobbling trace.
Why do I hear only a buzz on the radar question?
An over-the-horizon radar sweeps 10 to 20 kHz many times a second, and a 3 kHz receiver hears only the moment each sweep passes through it. The passes repeat 40 to 67 times a second, and that repetition is the buzz.
Sources
- Franke S, Somerville B, Taylor J (2020). The FT4 and FT8 Communication Protocols. QEX, July/August 2020. The tone spacings, symbol lengths, sync arrays, Gaussian smoothing and timing of FT8 and FT4.
- Taylor J et al. (2023). WSJT-X User Guide 2.6.1. The keying rates, bandwidths and transmission lengths of WSPR, FT8 and FT4.
- IARU Region 1 Monitoring System (accessed 14 November 2026). Radars. The sweep widths and sweep rates of over-the-horizon radars heard on shortwave.